The Ford Barn - View Single Post - 34 Ford and a 49-53 Engine

WRA · 11-14-2010, 07:48 PM

Here is my Flattie in my 34 Ford project. The adapters were found on Ebay, think they were around $70 (Ford Part #41A-6023) I also had to cut the flange off the crank pully so it would not hit the crossmember. I plan on using the stock radiator and 46-48 Distributor. Its a tight fit, less than an inch from the firewall.

1948 59A Pulley.jpg 009.jpg 008.jpg

11-14-2010, 07:48 PM	#7
WRA Senior Member Join Date: Sep 2010 Location: South of I-40 Posts: 379	Re: 34 Ford and a 49-53 Engine Here is my Flattie in my 34 Ford project. The adapters were found on Ebay, think they were around $70 (Ford Part #41A-6023) I also had to cut the flange off the crank pully so it would not hit the crossmember. I plan on using the stock radiator and 46-48 Distributor. Its a tight fit, less than an inch from the firewall. 1948 59A Pulley.jpg 009.jpg 008.jpg Last edited by WRA; 11-14-2010 at 08:24 PM.