Quote:
Originally Posted by Walt Dupont--Me.
Barler, how about those Canada blocks that came from the factory or army enginers with full flow filters, that just had the 1/4in. pipe thread holes like the the std. engine. Walt
|
Yes, the military engines and the post-war Ford Canada V8s with the full flow option used the 1/4" pipe thread oil ports, but remember that 1/4" pipe thread is bigger than 1/4", and a 1/4" pipe thread fitting for a 3/8" ID pressure hose or pipe will provide a 3/8"ID through it. The drawing from the '46 Ford Mercury Monarch parts manual shows the type available through '48, with 3/8" ID hard lines, and the later type available until the end of '51 used a different cannister and 3/8" flexible lines. Both used a similar fitting into the outboard oil port for the pressure line to the filter. ..B.