The Ford Barn - View Single Post

Merc Cruzer · 05-31-2011, 06:35 PM

rotowrench:

When I had it drilled for the 95% filter, it was because the block was out of the car! I had them block it off for now as I was going to use the origional system and later put the 95% filter system on. When I go to tear it down I will have to check to see if the grub screw is in the passage.....haven't pulled the rod caps off yet...stopped when I found the center main fried.

05-31-2011, 06:35 PM	#43
Merc Cruzer Senior Member Join Date: Jul 2010 Location: Conifer, Colorado Posts: 2,429	Re: Engine seized 2 miles after rebuild rotowrench: When I had it drilled for the 95% filter, it was because the block was out of the car! I had them block it off for now as I was going to use the origional system and later put the 95% filter system on. When I go to tear it down I will have to check to see if the grub screw is in the passage.....haven't pulled the rod caps off yet...stopped when I found the center main fried.