Re: Finding Babbiting Mains Repair Shop ?
Ya B-O-B, getting the look I want while using parts I have is still going to be expensive. Good "pre" 37 21 studders are hard to find. I want to avoid the water pump cover plates on the 37s.
I'm hoping to find a shop I can work with.
The 35 block I have currently uses a undersized crank with the only problem a chunk of babbit missing at the rear main. They probably shut it down with loss of oil pressure and pulled motor at that time.
My hope is maybe to find a shop that could repour just the rear main and then align bore the block back to standard. If a LB crank could have the mains turned to 1935 std main diameter, that could then possibly be used.
Not many shops doing custom old-timey machine work anymore, I guess.
Thanks D Jones, I see they are having a swap meet in Redmond, OR next weekend. Maybe will drive down and ask some of the seller there what they might know about a shop there.
|