Rear Axle Housing woes
Some time ago I posted about a leaking rear axle. When taking it apart, I realised that the Rear Axle Housing Cap and felt washer was wafer thin and needed replacing. Parts finally arrived. Question- is there a trick (apart from a piece of timber and a heavy hammer) to properly seat the Cap to the required depth to allow the brake drum and wheel hub to seat properly? Second question - and a tad embarrassing - when disassembling I forgot to note the positioning of the key. Where does the tapered section go? Seems that there are four possibilities.
Appreciate any advise that can be provided.
Cheers
John
Last edited by JohninKuranda; 08-29-2014 at 02:48 AM.
|