The Ford Barn - View Single Post - How well will a Pertronix module go on an old distributor cam (42-44 crab)

Bluebell · 07-30-2016, 07:31 PM

Bill, read the application notes on page 4. (same catalogue)
The following is "copy and pasted" directly from that page, without alteration.
" Ignitor II and Ignitor III kits are only available in 12-volt negative ground."

I guess the answer would be to contact them directly if you happened to want an Ignitor II in any alternative to 12 volt negative earth.

I have read some of your stuff on your web site. You do good work. I have read about your oil filter set up and your dizzy conversion. This leads me to ask how you arrived at your coil resistance comments.

07-30-2016, 07:31 PM	#19
Bluebell Senior Member Join Date: Nov 2012 Location: Tauranga, New Zealand Posts: 726	Re: How well will a Pertronix module go on an old distributor cam (42-44 crab) Bill, read the application notes on page 4. (same catalogue) The following is "copy and pasted" directly from that page, without alteration. " Ignitor II and Ignitor III kits are only available in 12-volt negative ground." I guess the answer would be to contact them directly if you happened to want an Ignitor II in any alternative to 12 volt negative earth. I have read some of your stuff on your web site. You do good work. I have read about your oil filter set up and your dizzy conversion. This leads me to ask how you arrived at your coil resistance comments. Last edited by Bluebell; 07-30-2016 at 07:55 PM.