The Ford Barn - View Single Post

Ol' Ron · 10-26-2019, 06:53 PM

Have seen a set on an engine quite a few years back. I was supprised to see cast iron instead of aluminum. That alone is a plus. However, I have no idea what the combustion chamber looks like. I would hope the plug was moved closer to the transfer area,. Good luck

10-26-2019, 06:53 PM	#7
Ol' Ron Senior Member Join Date: May 2010 Location: Chester Vt Posts: 8,862	Re: Ol' Ron & JWL ideas on CHAMPION HEADS Have seen a set on an engine quite a few years back. I was supprised to see cast iron instead of aluminum. That alone is a plus. However, I have no idea what the combustion chamber looks like. I would hope the plug was moved closer to the transfer area,. Good luck