View Single Post
Old 04-23-2016, 08:37 PM   #201
GB SISSON
Senior Member
 
GB SISSON's Avatar
 
Join Date: Jan 2014
Location: Orcas Island Washington
Posts: 2,047
Default Re: Truck based woody

I got the front door stiles laminated up and today I got a few hours to rough out the driver's door side. There are seven laminations of 3/8" maple and there will be one more on the outer surface. This outer layer will extend about 1/2" forward of the post, creating the forward lip which fits into the cowl's rabbet. Using this method allows me to bandsaw the inner door's contours to fit the door opening, then fit the last outer layer that shows. The 'built in place' finger joints created by offsetting my material should be really strong while maintaining a fair curve to match the vertical lines of the pickup cowl. This is a very labor intensive project.
Attached Images
File Type: jpg door posts 005.JPG (128.8 KB, 92 views)
File Type: jpg door posts 010.JPG (87.7 KB, 89 views)
File Type: jpg door posts 015.jpg (44.4 KB, 88 views)
File Type: jpg door posts 018.jpg (34.0 KB, 94 views)
File Type: jpg door posts 028.JPG (129.7 KB, 91 views)
File Type: jpg door posts 029.JPG (57.8 KB, 89 views)
__________________
'47 1/2 ton pickup next project, '47 one ton panel 99% stock nearing completion, '47 2 ton with 8ba and 9' script stakebed, '46 1/2 ton woodie project,'59 F350 9' flareside pickup with cummins 6at. 'Rusty ol' floorboards, hot on their feet' (Alan Jackson)
GB SISSON is offline   Reply With Quote