View Single Post
Old 11-15-2019, 07:19 PM   #10
Senior Member
redmodelt's Avatar
Join Date: May 2010
Location: Portland OR
Posts: 4,834
Default Re: Snyder’s Inserted Rod Size?

I know doing it yourself is fun, but at 90$ each for the rods, how much is your time worth? And yes I fully understand the bragging rights saying you did it yourself. If you have the tools and know how and can find the info you need, go for it. I was told today to do the job it should be bronze welded on the thrust area, faced on both sides equally, bored and honed. Then of course you will need a jig to keep your centers for machining.
I know the voices aren't real but damn they have some good ideas!
redmodelt is offline   Reply With Quote