Re: Rear Float-a-Motor Mount Install Issue
Quote:
Originally Posted by Railcarmover
Don't accept a misaligned motor mount issue on account that you dont hand crank the car.If the crank bearing (crank hole) doesnt align with the crankshaft your drive shaft is out of alignment as well.The ujoint will accommodate the misalignment,with a potential cost of increased vibration and wear.
|
In my case the crank bearing misalignment was caused by the front motor mount.
__________________
If you don't hear a rumor by 10 AM, start one!.
Got my education out behind the barn!
|