Quote:
Originally Posted by Brian
FYI on eBay now there is a Manzel 6306 timing gear puller which in conjunction with a step plate works wonders at removing the 4221 rear end carrier bearings in addition to the crank timing gear. I’d buy it if I didn’t already have three of them.
No disrespect intended, but why would you need three of these things? That's the thing with this 'hobby',: it can all too easily develop into a bad habit!!
|
No disrespect taken.
For me it’s not just a hobby. I do early ford work for a living. I use KR Wilson and specialty tools daily. For example I use my sun machine at minimum twice a day. I have four of them so that when one goes south I have another to rely on. Unlike a 1/2” wrench some of these tools are hard to find and I rely on them for every day use
Brian you make a good point that many of these tools are easy to make if you own a lathe or a mill like the seal drivers, etc.
Sent from my iPhone using Tapatalk