The Ford Barn - View Single Post

PeteVS · 10-19-2013, 02:54 PM

Dennis Lacy (found on the HAMB and possibly here) has a T on a '32 frame. I can't find the pictures, but he did a substantial 'Z' job at the rear of the frame to get the rear down. There are many ways to get the front down. The HAMB* is probably a better place to track down this type of information.

*Go down to 'Forum Jump' right at the bottom of this page and select 'Hot Rods and Customs.' If you're not a member on the Jalopy Journal, it's pretty much like starting out here. Same software, same Ryan. A little rowdier crew over there, however.

10-19-2013, 02:54 PM	#2
PeteVS Senior Member Join Date: May 2010 Location: FP, NJ Posts: 2,770	Re: How do they lower this? Dennis Lacy (found on the HAMB and possibly here) has a T on a '32 frame. I can't find the pictures, but he did a substantial 'Z' job at the rear of the frame to get the rear down. There are many ways to get the front down. The HAMB* is probably a better place to track down this type of information. *Go down to 'Forum Jump' right at the bottom of this page and select 'Hot Rods and Customs.' If you're not a member on the Jalopy Journal, it's pretty much like starting out here. Same software, same Ryan. A little rowdier crew over there, however. __________________ Don't never get rid of nuthin!