The Ford Barn - View Single Post

19Fordy · 12-14-2020, 03:07 PM

Best thing to do is to first sand blast that fender nice and clean inside and out. Do not point the nozzle 90 degrees to the metal. Keep it at an angle of 45 degrees and don't warp the metal. Then you can see what you have and make needed repairs.

12-14-2020, 03:07 PM	#5
19Fordy Senior Member Join Date: May 2010 Location: Coral Springs FL Posts: 10,936	Re: Sheet metal prep Best thing to do is to first sand blast that fender nice and clean inside and out. Do not point the nozzle 90 degrees to the metal. Keep it at an angle of 45 degrees and don't warp the metal. Then you can see what you have and make needed repairs.