View Single Post
Old 07-18-2016, 10:29 PM   #11
Andy
Senior Member
 
Join Date: May 2010
Location: Kerrville, Tx
Posts: 2,767
Default Re: 1935 wire wheels

You can measure the required spacer thickness pretty easily. Put a staight piece of metal across two of the supports on the wheel mounting surface. Measure down to the cavity the spacer sits in. Subtract the thickness of your metal piece and that is the gap that needs to be filled.
Check what the Speedway thickness is. Not the total thickness but the raised part.
Andy is offline   Reply With Quote