The Ford Barn - View Single Post

ahirt · 04-14-2021, 08:02 AM

Just did the same thing last week.. I did not sand any areas but I did clean the bolt holes well as well as the threads on the bolts themselves. I then used Loctite Copper Antiseize 8008 on the mounting holes and bolts. This antiseize is advertised as being highly conductive. When I checked the ground it was very good.

04-14-2021, 08:02 AM	#2
ahirt Senior Member Join Date: Nov 2014 Location: Stuart Florida Posts: 108	Re: Light Bar Repaint Question Just did the same thing last week.. I did not sand any areas but I did clean the bolt holes well as well as the threads on the bolts themselves. I then used Loctite Copper Antiseize 8008 on the mounting holes and bolts. This antiseize is advertised as being highly conductive. When I checked the ground it was very good.