The Ford Barn - View Single Post

chrs1961815 · 03-25-2020, 07:30 PM

I figured out the problem. The kit from Brattons had a wire about as thin as safety wire. The kit I got today from Snyders had a beefy wire that is very thick. I switched out the Brattons wire for the Snyders wire and after installation, it looked and felt much better.

I started on the cowl welting by drilling out the old pop rivets. The firewall and cowl panels don't quite mate up the way they are supposed to. The holes didn't quite line up. I inserted a split rivet to see and it is tight. But it will fix itself if I get a tight fit. I still am pondering how to get the split rivet nice and crimped and tight without the tool. A two man job yes, but what tools should be used?

03-25-2020, 07:30 PM	#7
chrs1961815 Senior Member Join Date: Jul 2018 Location: Spring Grove, Illinois Posts: 1,371	Re: Cowl Welting Problem I figured out the problem. The kit from Brattons had a wire about as thin as safety wire. The kit I got today from Snyders had a beefy wire that is very thick. I switched out the Brattons wire for the Snyders wire and after installation, it looked and felt much better. I started on the cowl welting by drilling out the old pop rivets. The firewall and cowl panels don't quite mate up the way they are supposed to. The holes didn't quite line up. I inserted a split rivet to see and it is tight. But it will fix itself if I get a tight fit. I still am pondering how to get the split rivet nice and crimped and tight without the tool. A two man job yes, but what tools should be used? __________________ "The more things change, the more they stay the same."