The Ford Barn - View Single Post

supereal · 06-09-2019, 02:37 PM

The driveshaft center bearing is held in position by the grease fitting on the torque tube. If the fitting was removed at some time the grease will not enter the bearing. The only way to test is to unscrew the fitting and use a wire to see if the bearing is there. Otherwise the grease just goes into the tube.

06-09-2019, 02:37 PM	#8
supereal Senior Member Join Date: Jul 2014 Location: Iowa Posts: 1,634	Re: Amount of grease for 46 Driveline The driveshaft center bearing is held in position by the grease fitting on the torque tube. If the fitting was removed at some time the grease will not enter the bearing. The only way to test is to unscrew the fitting and use a wire to see if the bearing is there. Otherwise the grease just goes into the tube.