Quote:
Originally Posted by 51woodie
I’m not sure what the PO did as far as greasing the driveline, or how much is already in the u-joint or driveshaft bearing, so the questions are:
Can the u-joint/clamshell be overgreased?
If too much grease, will it get into the speedo drive/able?
Can the driveshaft bearing be over greased?
Again, I don’t know how much grease is already in these areas.
|
Yes the U joint needs to be full, it takes a full tube. To much go's
into the transmission. It comes out rear of the split cover when
full. The center drive shaft bearing only needs two pumps on the
grease gun once a year. G.M.