View Single Post
Old 09-23-2011, 09:29 AM   #5
allison-tech
Member
 
allison-tech's Avatar
 
Join Date: Sep 2011
Location: Huffman, Texas
Posts: 41
Default Re: Milling a head for compression?

Thank-you both for the responses, I would like to get the most out of my engine w/o any bolt-on aftermarket access. I try to keep in mind that this car, as a whole assy. was built for low HP. My performance is achieved w/a correct tune & I would like to get as much as I can w/o needing to upgrade other components to handle the extra HP. I'd love to get 50 hp w/my original parts. I think I will take off .125 and see how it does.
allison-tech is offline   Reply With Quote