The Ford Barn - View Single Post

Mart · 07-13-2018, 03:37 PM

The bolt is the original long bolt that is used in the lower two holes and normally go through the radius arm. The nut is a special, used with a tube shock conversion. The bolt will take a standard castellated nut if the shock conversion is not required.

07-13-2018, 03:37 PM	#11
Mart Senior Member Join Date: May 2010 Location: Solihull, England. Posts: 8,755	Re: Bolts that hold backing plate 39 ford The bolt is the original long bolt that is used in the lower two holes and normally go through the radius arm. The nut is a special, used with a tube shock conversion. The bolt will take a standard castellated nut if the shock conversion is not required.