Front end tollerences...
Most of us, if not all, would like to have the front end assembly, when attached to the front cross member and measured from equal points, A to B, left and right, be almost equal.
However sometimes they are not equal.
In other words, pick a point on the front end (A) and measure to a "given" point (B) on the frame, left and right. They should be equal or darn near close to it but sometimes they are not.
With that said...Just how much of a tollerence is acceptable if one can not adjust the "problem", if in fact it is a problem, to get to where both sides are equal? 1/16"?, 2/16"?, 3/16"?
Thanks.
Pluck
|