Quote:
Originally Posted by Thearne3
Yes. Definitely! With the part numbers, where do we go to get prints?
This is very helpful - and daunting! What would you say to using a 2+ pound expanding foam? It would definitely provide structural support and conform completely to the inside of the steel. The goal would be: hard enough to support, but not so hard that staples can't penetrate.
|
Prints are available at the Benson Library for $35 a piece as I recall.
I would think that expanding foam would not be a prudent idea. Again, you need something as strong as wood ...however as flexible as wood.
I tried to return your call.