View Single Post
Old 09-24-2011, 09:55 AM   #30
29restorod
Senior Member
 
29restorod's Avatar
 
Join Date: Jul 2011
Location: South East Michigan
Posts: 229
Default Re: Milling a head for compression?

Wick,we always said it was 1/3-Machine,1/3-driver,1/3-luck. The best driver,with the best kart,could have a lot of bad luck. I did the wheel bearing thing,just like you,new bearings every race,seal lips cut off,and chain lube,instead of grease.
__________________
If you think SBC's are "Old School" you are not old enough.
29restorod is offline   Reply With Quote