View Single Post
Old 09-23-2011, 02:10 PM   #23
Wick
Senior Member
 
Wick's Avatar
 
Join Date: May 2010
Location: Gwynn's Island Va
Posts: 1,243
Default Re: Milling a head for compression?

Yea,Brent I learned alot! I was allways told 10% motor 10% Driver 80% Kart.
Milling Heads,profileing Cams,checking lifters,Flow testing carbs and weighing every moving part! it all added up. Also make sure when your wide open that the carb is wide open too! This can all be used on the Model A.
Wick
Wick is offline   Reply With Quote