Checking generator output
Ok, need a little advice here. Please see the attached picture. I have my multi meter connected to the generator as seen in the picture, neg. lead to terminal on regulator and pos. lead grounded. My meter is set to 10V DC. At a fast idle the meter is reading right at 6.9 volts. Is my connection correct for this test and if so is 6.9 volts ok? NOTE, that is a voltage regulator on the generator not the original cut out. Thanks
Last edited by Standing Elk; 09-10-2019 at 03:04 PM.
Reason: need to add picture
|