Quote:
Originally Posted by slammin
I mounted mine thru the floor under the driers seat, using #2 copper wire. I also added another ground cable over to the tranny mount.
|
I did run another 4 gauge ground cable from a spot i cleaned down to bare metal on the frame and then to a clean spot on the bell housing. I'm also going to run another one on the passenger side in the same spots for peace of mind.
We''ll see how it works.
The starter spins waaaayyy faster with the ground attached! Very noticeable difference!
When I get some worn engine parts replaced I will replace all motor mounts and clean the frame to regain some lost frame ground.