Quote:
Originally Posted by Cave
Nice install Smooth_One! The PO installed the same one in my '31 coupe. To save opening the hood so often I fabricated an extension rod that reaches the switch and protrudes out a little under the hood (there was adequate clearance without having to modify the hood).
Attachment 387864
Attachment 387865
Attachment 387866
Attachment 387867
Attachment 387868
I drilled and tapped the switch handle to accommodate the eyebolt and put a dab of JBWeld (not shown) on it to keep it snug. I bent a 1/4" threaded rod - note: I ground off the threads before heating and bending, experience told me that threads sometimes tear through the stock when bent. Then I covered it with 1/4" shrink tubing to hide the threads. Finally one more stainless steel eyebolt to make an outside support.
Purists will balk, I'm ok, I drive it for me, not others.
|
Very nice. Thanks for sharing! Simple but clean fab work there.