The Ford Barn - View Single Post

rotorwrench · 12-17-2014, 07:23 PM

Some of the new aluminum heads have the stud holes bored to a larger diameter but this has made several folks install locating pins to keep the head properly aligned during torque up.

12-17-2014, 07:23 PM	#15
rotorwrench Senior Member Join Date: Jun 2010 Location: San Antonio, Texas Posts: 16,425	Re: head puller Some of the new aluminum heads have the stud holes bored to a larger diameter but this has made several folks install locating pins to keep the head properly aligned during torque up.