Quote:
Originally Posted by bbrocksr
If you look close at Dominic's picture on the right the plate is supposed to go between the first and second lands on the valve. The first land is on the outside as pictured and the plate will stop the second land from coming out as shown by the wear marks on the plate. Hopefully you didn't file too much off.
Bill
|
Oops. I did file it off. Now it slides completely through. I wish I'd known that's how it was supposed to work.
Dad has an extra valve body at the house that Should have that piece intact that I can grab.
If I did install it the way it is now, I'm guessing it would get stuck? Possibly too low line pressure?