The Ford Barn - View Single Post - Difference between RH and LH backing plates?

PeteVS · 10-31-2017, 05:58 AM

I think (and I could very easily be wrong) that there's a couple of degrees difference in the "clocking" of the four holes that bolt to the spindle in order to place the wheel cylinder at the top dead center allowing for caster? Or, is that camber?

10-31-2017, 05:58 AM	#5
PeteVS Senior Member Join Date: May 2010 Location: FP, NJ Posts: 2,770	Re: Difference between RH and LH backing plates? I think (and I could very easily be wrong) that there's a couple of degrees difference in the "clocking" of the four holes that bolt to the spindle in order to place the wheel cylinder at the top dead center allowing for caster? Or, is that camber? __________________ Don't never get rid of nuthin!