The Ford Barn - View Single Post

craig · 01-17-2022, 03:41 PM

If the fork is now in deeper or shallower than it was, not centering the T.O. bearing, then is it possible you re-attached the pivot bracket backwards. It's a 90 degree piece, if turned around then it would pivot the fork in a different location

01-17-2022, 03:41 PM	#2
craig Senior Member Join Date: May 2010 Location: The Inland Empire of Washington State Posts: 368	Re: 68 Mustang Clutch Release Lever If the fork is now in deeper or shallower than it was, not centering the T.O. bearing, then is it possible you re-attached the pivot bracket backwards. It's a 90 degree piece, if turned around then it would pivot the fork in a different location