The Ford Barn - View Single Post

Gino · 01-17-2022, 03:06 PM

Ok, Im back. I wish I could say everything worked out, but thats not the case. This will be a long story, I hope you folks will stick with me. 200 CI. 6 CYL. Manual three speed synchronized transmission. Bell housing is C7ZA-6394-A.
One of the two rivets that attach the clutch release lever to the bell housing failed. I pulled it all down, got the bell housing on the work bench and performed the repair to the lever bracket. I then installed the lever with a new anti rattle spring and realized the throw out bearing was or is not in the center of the hole. Obviously the trans side. The existing lever is 9 long, if that helps. This is over my head but I have to do the job. Any help would be much appreciated.

01-17-2022, 03:06 PM	#1
Gino Senior Member Join Date: Oct 2011 Location: Falmouth, Ma. Posts: 313	68 Mustang Clutch Release Lever Ok, Im back. I wish I could say everything worked out, but thats not the case. This will be a long story, I hope you folks will stick with me. 200 CI. 6 CYL. Manual three speed synchronized transmission. Bell housing is C7ZA-6394-A. One of the two rivets that attach the clutch release lever to the bell housing failed. I pulled it all down, got the bell housing on the work bench and performed the repair to the lever bracket. I then installed the lever with a new anti rattle spring and realized the throw out bearing was or is not in the center of the hole. Obviously the trans side. The existing lever is 9 long, if that helps. This is over my head but I have to do the job. Any help would be much appreciated.