The Ford Barn - View Single Post

LSJUNIPER · 02-25-2013, 11:40 AM

Thanks for all of the advise, Marvel mystery oil, OK will do. The cylinders mic out at 3.06 dia. Will keep you all posted on my progress. Mart I will figure out a better way to prop the motor. For now was thinking of supporting the end opposite the stand with a saw horse???

02-25-2013, 11:40 AM	#18
LSJUNIPER Senior Member Join Date: Aug 2011 Location: CT Posts: 215	Re: Flathead project Thanks for all of the advise, Marvel mystery oil, OK will do. The cylinders mic out at 3.06 dia. Will keep you all posted on my progress. Mart I will figure out a better way to prop the motor. For now was thinking of supporting the end opposite the stand with a saw horse??? Last edited by LSJUNIPER; 02-25-2013 at 11:57 AM.