The Ford Barn - View Single Post

artron9 · 05-21-2019, 03:53 PM

Back again! Just when everything was working great, I noticed today that my oil pressure gauge on my 52 Vic was at zero and did not move. Up till today, it worked fine. It always took its time to get up to 50-60 psi but it would get there. My guess is its the sending unit. But then again it could be the gauge. Could be the original wiring? There is plenty of oil. Not sure where to begin. Don't want to spend $40+ on a sending unit if I don't have to! What would you do???

05-21-2019, 03:53 PM	#1
artron9 Senior Member Join Date: Nov 2016 Location: Lexington MA Posts: 133	oil pressure gauge Back again! Just when everything was working great, I noticed today that my oil pressure gauge on my 52 Vic was at zero and did not move. Up till today, it worked fine. It always took its time to get up to 50-60 psi but it would get there. My guess is its the sending unit. But then again it could be the gauge. Could be the original wiring? There is plenty of oil. Not sure where to begin. Don't want to spend $40+ on a sending unit if I don't have to! What would you do???