The Ford Barn - View Single Post

Tinker · 03-28-2018, 12:21 PM

Are you taking the edelbrock heads off or are you removing heads to put them on a block?

The reason I asked is because I had a set of vintage edelbrock 7.5 aluminum heads that we put on a friends engine. After they where on, we hand cranked the motor over. There was some interference somewhere and the motor wouldn't budge. Turns out the heads had been over milled. Luckily we didn't fire the motor up. Might not be your case.

03-28-2018, 12:21 PM	#5
Tinker Senior Member Join Date: May 2010 Location: MN Posts: 7,053	Re: Vintage Edelbrock heads Are you taking the edelbrock heads off or are you removing heads to put them on a block? The reason I asked is because I had a set of vintage edelbrock 7.5 aluminum heads that we put on a friends engine. After they where on, we hand cranked the motor over. There was some interference somewhere and the motor wouldn't budge. Turns out the heads had been over milled. Luckily we didn't fire the motor up. Might not be your case. Last edited by Tinker; 03-28-2018 at 12:30 PM.