The Ford Barn - View Single Post

duke36 · 03-22-2019, 01:08 PM

If you don't mind a non stock setup, what I used to do with inside shutoff valves was drain the fuel, remove the valve, install a common brass elbow in the tank bottom to receive the stock gas line/ fittings. Then measure for a 1/8" ball valve from a home supply store, etc.and remove the small line section out. Install compression fittings. I've never had a leak and fuss as common with the orig. valves. The ball valves should be good for ethanol gas.

03-22-2019, 01:08 PM	#8
duke36 Senior Member Join Date: Jun 2015 Posts: 1,414	Re: Gas shutoff valve If you don't mind a non stock setup, what I used to do with inside shutoff valves was drain the fuel, remove the valve, install a common brass elbow in the tank bottom to receive the stock gas line/ fittings. Then measure for a 1/8" ball valve from a home supply store, etc.and remove the small line section out. Install compression fittings. I've never had a leak and fuss as common with the orig. valves. The ball valves should be good for ethanol gas.