The Ford Barn - View Single Post

19Fordy · 01-24-2019, 07:24 AM

The only way to know for sure is to check it for balance. Looks like a friction saw attacked it.
I would NOT use it. Your entire engine would literally "revolve" around that cut. Hard to believe it was that much "out". Not worth taking the gamble.

01-24-2019, 07:24 AM	#7
19Fordy Senior Member Join Date: May 2010 Location: Coral Springs FL Posts: 10,949	Re: Mercury crankshaft The only way to know for sure is to check it for balance. Looks like a friction saw attacked it. I would NOT use it. Your entire engine would literally "revolve" around that cut. Hard to believe it was that much "out". Not worth taking the gamble. Last edited by 19Fordy; 01-24-2019 at 08:53 AM.