View Single Post
Old 06-21-2018, 07:03 PM   #9
rotorwrench
Senior Member
 
rotorwrench's Avatar
 
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 16,368
Default Re: 8BA Flywheel/Clutch....I've Read TOO Much

Take a look at this old link. https://fordbarn.com/forum/showthrea...lling+flywheel
With a jig it would be less of a problem. A good drill press could drill the starter hole then finish off with a good tap after any re-centering if required and finish drilling for the correct tap size. 8BA flywheels are drilled through so no bottoming tap would be needed.

If a person has a good mill and a rotary index table, the jig really wouldn't be needed. Most machine shops should be able to do this.

Last edited by rotorwrench; 06-21-2018 at 07:09 PM.
rotorwrench is online now   Reply With Quote