[BILL WILLIAMSON]

Originally Posted by Ron in Quincy

You can use a plain copper scrub pad, cut a large piece and place it in the tube under the oil cap, push it down to the louvers. As the oil collects on the pad it will run back into the oil pan and not end up on the left side of the engine.

Works well for me for a lot of years.

Ron

BUT, adding ANYTHING, in the tube or cap raises crankcase pressure & causes more leakage, especially at the REAR MAIN.
Mist is mainly a problem at higher speeds & longer runs, THEN, just use a sock & don't WURRY about it. It's just one of Model As IDIOSYNCHROCIES!
IDIOSYNCHRIC, was Greggs, (RIP!) one word definition of me! I considered it as a COMPLIMENT.
Bill Practical