View Single Post
Old 11-08-2019, 09:18 AM   #18
Bored&Stroked
Senior Member
 
Bored&Stroked's Avatar
 
Join Date: Jan 2011
Location: Central Ohio
Posts: 2,428
Default Re: 8BA Valve length

If all you're worried about is that on one side the valve is a bit longer (as far as installed spring height), just shim the spring to the correct installed height you're looking for - or use offset valve keepers.

You were only talking about .040 . . . which is obviously less than one .060 spring shim. I can see no need for custom guides - though Gary's guides are good to use regardless of the perceived spring stack height issue (his regular ones).

First of all - just measure your current installed spring height - how many shims do you need to get to 2.00"? Also, you might just consider some lash caps for the "tall" side.
Bored&Stroked is offline   Reply With Quote