View Single Post
Old 08-03-2019, 08:57 PM   #7
Pete
Senior Member
 
Pete's Avatar
 
Join Date: May 2010
Location: Wa.
Posts: 3,481
Default Re: Splitting a wishbone

Quote:
Originally Posted by Joes32 View Post
Hello, can anyone tell me if itís common to sleeve a bung for a tighter fit when preparing to weld? Iím guessing I had better try to but not as yet sure I have enough slop to be required... 🤔
Thank you, Joe
Stick a piece of solid rod the same diameter as the bung in the end. Heat the radius rod red and work the end down tapered over the rod with a wide face body hammer. Pull the rod. Drill a couple holes for rosette welds and TIG weld the holes and the circumference.
If this for the street, you can get away with smoothing off the welds.
Most race associations will not allow grinding welds smooth.
Pete is offline   Reply With Quote