The Ford Barn - View Single Post

Charlie Stephens · 02-19-2020, 06:57 PM

Use the Model B gasket with either the B head or the high compression Model A head and the steam holes are covered so the problem is gone. I am basing this on all of the High compression Model A heads I have ever seen. I assume you are running this in a Model A, if not then what?

Charlie Stephens

02-19-2020, 06:57 PM	#18
Charlie Stephens Senior Member Join Date: May 2010 Location: Southern California Posts: 7,033	Re: A head on B engine Use the Model B gasket with either the B head or the high compression Model A head and the steam holes are covered so the problem is gone. I am basing this on all of the High compression Model A heads I have ever seen. I assume you are running this in a Model A, if not then what? Charlie Stephens