Quote:
Originally Posted by Brentwood Bob
Matching tops and bottoms has been the time consuming operation. The Restorer series by Schmauch clarified that process.
|
Bob, I'm in the process of restoring about a dozen zenith carburetors and was wondering about how to match up the tops and bottoms correctly. I searched but couldn't find that article by Schmauch. I checked the MAFCA "how to restore the Model 'A'" Technical article index but no luck. Any clues where I might find that publication?
It is so much fun rebuilding these old Zenith Carburetors. Built a jet flow tester, a float gauge, and made an electrolysis vat to remove rust (worked great too). Figuring out how to gently take apart frozen carburetors is quite the challenge.