View Single Post
Old 09-19-2017, 02:27 PM   #22
BRENT in 10-uh-C
Senior Member
 
BRENT in 10-uh-C's Avatar
 
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,521
Default Re: Removing side mount tires-how ??

Quote:
Originally Posted by mike657894 View Post
the tires are over the spec that the well was designed for. or the well was put in slightly incorrectly. This reminds me i still haven't found a good jack to put in my car yet. its not on the roads yet.

You are spot-on. Ironically, a Coker Firestone 19" will fit in & out of an original welled fender fully inflated. For those that might be struggling with accepting this as fact, might I suggest you order a factory print that has the correct measurements and do a comparison towards the fender that won't. More often than not, most restorers (-including the gentleman at the Hershey show) do not install the well correctly. In addition, the repro well is not shaped correctly which compounds the egress issue.


.
Attached Images
File Type: jpg WellPrint_Notice.jpg (63.0 KB, 29 views)
__________________
.

BRENT in 10-uh-C
.
www.model-a-ford.com
...(...Finally Updated!! )

.
BRENT in 10-uh-C is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)