The Ford Barn - View Single Post

GordonC · 01-24-2018, 09:12 AM

pooch I only had a 1/8" drill for that chuck so thats what they got. I'll see if I can round up a 3/16". The end of a 1/8" straight punch fits nicely in it but I wondered what would happen should you break the tip? You'd probably have to pull that valve assembly and get the lifter out and remove any broken part of the punch. So going to 3/16" won't hurt my feelings at all! Thanks.

01-24-2018, 09:12 AM	#212
GordonC Senior Member Join Date: May 2010 Posts: 201	Re: Rebuilt Flathead Problems. pooch I only had a 1/8" drill for that chuck so thats what they got. I'll see if I can round up a 3/16". The end of a 1/8" straight punch fits nicely in it but I wondered what would happen should you break the tip? You'd probably have to pull that valve assembly and get the lifter out and remove any broken part of the punch. So going to 3/16" won't hurt my feelings at all! Thanks.