The Ford Barn - View Single Post - Help! - pitman arm on 34pu needs moved counterclockwise

Mart · 08-29-2013, 12:13 PM

Agree with SUHR.

I did one recently. I first made a cut with a hacksaw through the dead splines, then opened the cut out with a good triangular file. It didn't take too long at all.

Mart.

08-29-2013, 12:13 PM	#4
Mart Senior Member Join Date: May 2010 Location: Solihull, England. Posts: 8,754	Re: Help! - pitman arm on 34pu needs moved counterclockwise Agree with SUHR. I did one recently. I first made a cut with a hacksaw through the dead splines, then opened the cut out with a good triangular file. It didn't take too long at all. Mart.