Quote:
Originally Posted by amodel25
The outer ports (1 and 6) are exactly the same distance on the 200 cu in Falcon as the flat 6. The inner two (3 and 4) are within 1/8" each. The 2 and 5 are about 5/8" off each. There is a company in Tennessee (I'll have to look it up) that sells a plasma cut flat 6 flange. I cut off the Falcon flange, heat adjusted the #2 and #5 tubes, used some short sections of 1-1/4" u-bend pipes and welded it up. It turned out pretty nice. Again, if I can figure out how to post pictures I will.
|
I think I know what company you are talking about. Victory Speed Equipment.