Re: Oil mist on left side of engine
All A engines have to breath, that is why all oil tubes are not the same, Ford no doubt was getting complaints about blow by, you do not have to have worn rings to have blow by.
This is why I suggested, for a quick fix, using a copper scower pad as it is course and even though it collects oil fumes it still allows the engine to breath.
If you go to swap meets you might find an old Fumaze which has a special bracket that holds it in place, a lid that opens for adding or changing oil, a tube that extends down about 1 foot to carry the fumes out.
Do not use steel wool as it is fine and you will end up with some of it going into the oil pan, bad deal !!!!!!
Ron
Last edited by Ron in Quincy; 04-18-2018 at 11:10 AM.
Reason: To move post
|