The Ford Barn - View Single Post

GB SISSON · 12-09-2019, 11:22 PM

I'm on a 12 v coil running through a ceramic resistor on the firewall. I have some early v8 condensors. What do I wire to and do I need to remove the condenser that's in there? Thinking the condenser body screws to ground and the wire connector to movable point, stationary point????? Oh and I pulled the manifolds off today after work and flattened them on my 3' edge sander. Found a set of manifold gaskets hanging on a nail and that part is done. Sealed up tight. One more thing..... Here's a quick slideshow of my last project.

https://spark.adobe.com/video/M0ynvLlPj2GCC

12-09-2019, 11:22 PM	#23
GB SISSON Senior Member Join Date: Jan 2014 Location: Orcas Island Washington Posts: 4,911	Re: What did I just buy? I'm on a 12 v coil running through a ceramic resistor on the firewall. I have some early v8 condensors. What do I wire to and do I need to remove the condenser that's in there? Thinking the condenser body screws to ground and the wire connector to movable point, stationary point????? Oh and I pulled the manifolds off today after work and flattened them on my 3' edge sander. Found a set of manifold gaskets hanging on a nail and that part is done. Sealed up tight. One more thing..... Here's a quick slideshow of my last project. https://spark.adobe.com/video/M0ynvLlPj2GCC __________________ Owner/Operator of 'Jailbar Ranch' on the side of Mt. Pickett. Current stable consists of 1946 1/2 ton pickup turned woodie wagon with FH V8, 1947 Tonner Pickup (red) mostly stock with exception of a cummins 6at turbo diesel, 1946 Tonner Pickup (green) with 226 cu in 6 cyl flathead, 1979 Toyota landcruiser wagon, completely encased in 1947 Ford Jailbar sheet metal. Ok, cornbinder rear fenders..... 'Rusty ol' floorboards, hot on their feet' (Alan Jackson) Last edited by GB SISSON; 12-09-2019 at 11:28 PM.