More progress, this time on the side body panels. We are finally installing some rivets! Bob did a large amount of work detailing the panels and them metal finishing them to the vision that I described to him, and it turned out to be a GREAT job. He is shown using a home made hammer that was made for me by Mike Yurko a few years back. In one of the pictures, I am using a tool to de-burr rivet holes that was made for me by Billy Jack in Minnesota at one of Dan Pate's meet. Bob crawled around and under the car with the backing buck and I rolled back and forth with the rivet gun and it got to be smooth process after a while. Learning a lot about riveting.
BobThursday 003.jpg
BobThursday 004.jpg
BobThursday 006.jpg
BobThursday 007.jpg
BobThursday 008.jpg
BobThursday 009.jpg
BobThursday 014.jpg